mad detect mode relay

Function

The mad detect mode relay command configures multi-active detection (MAD) in relay mode on an interface.

The undo mad detect command cancels the configuration.

By default, MAD in relay mode is disabled on an interface.

Format

mad detect mode relay

undo mad detect [ mode relay ]

Parameters

None

Views

Eth-Trunk interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To ensure that only one switch becomes the master switch after a stack splits, thereby enhancing stability of the stack, run the mad detect mode relay command to configure MAD in relay mode on an Eth-trunk.

Precautions

The undo mad detect command is not supported in the port group view. You can only run the undo mad detect mode relay command in the port group view to disable MAD in relay mode.

Example

# Configure MAD in relay mode on Eth-Trunk 10.

<HUAWEI> system-view
[HUAWEI] interface eth-trunk 10
[HUAWEI-Eth-Trunk10] mad detect mode relay