mld-snooping enable (AP wired port profile view)

Function

The mld-snooping enable command enables MLD snooping on an AP's wired interface.

The undo mld-snooping enable command disables MLD snooping on an AP's wired interface.

By default, MLD snooping is disabled on an AP's wired interface.

Format

mld-snooping enable

undo mld-snooping enable

Parameters

None

Views

AP wired port profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

MLD snooping is a basic IPv6 Layer 2 multicast function that forwards and controls multicast traffic at the data link layer. MLD snooping runs on a Layer 2 device and analyzes MLD messages exchanged between a Layer 3 device and hosts to set up and maintain a Layer 2 multicast forwarding table. The Layer 2 device forwards multicast packets based on the Layer 2 multicast forwarding table.

Prerequisites

An AP wired port profile has been created.

Precautions

The AP wired interfaces added to an Eth-trunk interface do not support this function.

Example

# Enable MLD snooping on AP wired port profile p1.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] wired-port-profile name p1
[HUAWEI-wlan-wired-port-p1] mld-snooping enable