mpls l2vpn no-request-message

Function

The mpls l2vpn no-request-message command disables the device from sending L2VPN label request messages to a specified peer.

The undo mpls l2vpn no-request-message command re-enables the device to send L2VPN label request messages to a specified peer.

By default, the system sends L2VPN label request messages to all its peers.

Format

mpls l2vpn no-request-message peer ip-address

undo mpls l2vpn no-request-message peer ip-address

Parameters

Parameter	Description	Value
peer ip-address	Specifies the LSR ID of a peer device on the PW.	The value is in dotted decimal notation.

Views

MPLS-L2VPN view

Default Level

2: Configuration level

Usage Guidelines

On a PW in PWE3/Martini mode between two PEs with a Huawei device functioning as one PE and a non-Huawei device functioning as the other, if the non-Huawei device does not have the capability of processing L2VPN label requests, the mpls l2vpn no-request-message command needs to be run on the Huawei device to allow communication between the two devices. This command cannot be used in other cases.

Example

# Disable the device from sending L2VPN label request messages to a peer with the LSR ID being 10.2.2.9.

<HUAWEI> system-view
[HUAWEI] mpls l2vpn
[HUAWEI-l2vpn] mpls l2vpn no-request-message peer 10.2.2.9