The mpls ldp timer igp-sync-delay command sets the interval during which an LSP is being set up after an LDP session is created.
The undo mpls ldp timer igp-sync-delay command restores the default setting.
By default, the interval is 10 seconds.
Parameter | Description | Value |
---|---|---|
value | Specifies the interval, during which an LSP is being set up after an LDP session is created. | The value is an integer ranging from 0 to 65535, in seconds. |
VLANIF interface view, GE interface view, XGE interface view, MultiGE interface view, 25GE interface view, 40GE interface view, 100GE interface view, Eth-trunk interface view, remote MPLS LDP peer view
LDP-Interior Gateway Protocol (IGP) synchronization-enabled devices complete to establish an LDP session earlier than an LSP. The mpls ldp timer igp-sync-delay command can be used to switch traffic to the established LSP after a specified period of time. This setting prevents traffic loss that occurs if the LDP session in the Up state attempts to switch traffic to the LSP that has not been established. Using the default delay value is recommended.
<HUAWEI> system-view [HUAWEI] interface vlanif 100 [HUAWEI-Vlanif100] mpls ldp [HUAWEI-Vlanif100] mpls ldp timer igp-sync-delay 15
<HUAWEI> system-view [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] undo portswitch [HUAWEI-GigabitEthernet0/0/1] mpls ldp [HUAWEI-GigabitEthernet0/0/1] mpls ldp timer igp-sync-delay 15
<HUAWEI> system-view [HUAWEI] mpls ldp remote-peer rta [HUAWEI-mpls-ldp-remote-rta] mpls ldp timer igp-sync-delay 15