mpls te bandwidth max-reservable-bandwidth
Function
The mpls te bandwidth max-reservable-bandwidth command sets or modifies the maximum reservable bandwidth of a link.
The undo mpls te bandwidth max-reservable-bandwidth command restores the default configuration.
The maximum reservable bandwidth of a link is not configured by default.
Format
mpls te bandwidth max-reservable-bandwidth bw-value
undo mpls te bandwidth max-reservable-bandwidth
Parameters
| Parameter | Description | Value |
|---|---|---|
| bw-value | Specifies the maximum reservable bandwidth of a link. | The value is an integer that ranges from 0 to 4000000000, in kbit/s. The default value is 0. |
Views
VLANIF interface view, GE interface view, XGE interface view, MultiGE interface view, 25GE interface view, 40GE interface view, 100GE interface view, Eth-trunk interface view
Usage Guidelines
In practical applications, the mpls te bandwidth max-reservable-bandwidth command can be configured for a TE tunnel on an outgoing interface of the link through which the tunnel passes.
The configured bandwidth takes effect only during tunnel establishment and protocol negotiation, and does not limit the bandwidth for traffic forwarding. (S5720-HI does not have this restriction.)
Example
# Set the maximum reservable bandwidth of the link to 10000 kbit/s on interface VLANIF100.
<HUAWEI> system-view [HUAWEI] interface vlanif 100 [HUAWEI-Vlanif100] mpls [HUAWEI-Vlanif100] mpls te [HUAWEI-Vlanif100] mpls te bandwidth max-reservable-bandwidth 10000
<HUAWEI> system-view [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] undo portswitch [HUAWEI-GigabitEthernet0/0/1] mpls [HUAWEI-GigabitEthernet0/0/1] mpls te [HUAWEI-GigabitEthernet0/0/1] mpls te bandwidth max-reservable-bandwidth 10000