multicast-rate

Function

The multicast-rate command configures the multicast rate of wireless packets in a radio profile.

The undo multicast-rate command restores the default multicast rate of wireless packets in a radio profile.

By default, the multicast rate of wireless packets is not configured in a radio profile. That is, the multicast rate is set to auto-sensing.

Format

multicast-rate multicast-rate

undo multicast-rate

Parameters

Parameter	Description	Value
multicast-rate	Specifies the multicast rate of wireless packets in a radio profile.	Enumerated type. The values are as follows in a 2G radio profile: 1: 1 Mbps 2: 2 Mbps 5: 5.5 Mbps 6: 6 Mbps 9: 9 Mbps 11: 11 Mbps 12: 12 Mbps 18: 18 Mbps 24: 24 Mbps 36: 36 Mbps 48: 48 Mbps 54: 54 Mbps The values are as follows in a 5G radio profile: 6: 6 Mbps 9: 9 Mbps 12: 12 Mbps 18: 18 Mbps 24: 24 Mbps 36: 36 Mbps 48: 48 Mbps 54: 54 Mbps

Views

2G radio profile view, 5G radio profile view

Default Level

2: Configuration level

Usage Guidelines

After this command is run, the multicast rate of wireless packets is the configured value and irrelevant to the STA access mode.

If the configured multicast rate is not in the basic rate set and the STA does not support this rate, the STA cannot receive multicast data.

If you run the radio-type dot11b command in the 2G radio profile view to set the radio type to dot11b, and the 2G radio profile is applied to an AP, multicast-rate that takes effect on the 2 GHz radio of the AP is fixed as 1 Mbps, and multicast-rate configured in the 2G radio profile view does not take effect on the AP.

Example

# Set the multicast rate of wireless packets to 54 Mbps in the 2G radio profile.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] radio-2g-profile name default
[HUAWEI-wlan-radio-2g-prof-default] multicast-rate 54