nd snooping alarm binding-table check threshold

Function

The nd snooping alarm binding-table check threshold command configures the alarm threshold for the number of ND snooping-discarded packets.

The undo nd snooping alarm binding-table check threshold command restores the default alarm threshold.

By default, the global alarm threshold for the number of ND snooping-discarded packets is 100, and the alarm threshold for the number of ND snooping-discarded packets on an interface is the value configured in the system view.

Format

nd snooping alarm binding-table check threshold threshold

undo nd snooping alarm binding-table check threshold

Parameters

Parameter	Description	Value
threshold	Specifies the alarm threshold for the number of ND snooping-discarded packets.	The value is an integer that ranges from 1 to 1000.

Views

System view, Ethernet interface view, GE interface view, XGE interface view, 25GE interface view, MultiGE interface view, 40GE interface view, 100GE interface view, Eth-Trunk interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After the alarm function for checking packets against the ND snooping binding table is enabled using the nd snooping alarm binding-table check enable command, you can run the nd snooping alarm binding-table check threshold command to configure the alarm threshold for the number of ND snooping-discarded packets.

Prerequisites

ND snooping has been enabled on the device using the nd snooping enable command.

Precautions

If this command is run in the system view, it takes effect on all the interfaces of the device.

Example

# Set the alarm threshold for the number of ND snooping-discarded packets on GE0/0/1 to 1000.

<HUAWEI> system-view
[HUAWEI] nd snooping enable
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] nd snooping alarm binding-table check threshold 1000