The ospfv3 timer poll command sets the polling interval for sending Hello packets on NBMA network.
The undo ospfv3 timer poll command restores the default polling interval.
By default, the polling interval for sending Hello packets on NBMA network is 120 seconds.
ospfv3 timer poll interval [ instance instance-id ]
undo ospfv3 timer poll [ interval ] [ instance instance-id ]
| Parameter | Description | Value |
|---|---|---|
interval |
Specifies the polling interval of Hello packets. |
The value is an integer ranging from 1 to 65535, in seconds. |
instance instance-id |
Specifies the instance ID of the interface. |
The value is an integer ranging from 0 to 255. The default value is 0. |
On the NBMA network, if a neighbor is invalid, you can configure switches to send Hello packet based on the polling interval that is set by the ospfv3 timer poll command. The polling interval should be at least 4 times that of the Hello interval.
OSPFv3 does not support the configuration on a null interface.
Before running this command on an interface, run the ospfv3 area command on the interface to enable OSPFv3.
# Set the polling interval for sending Hello packets on the Vlanif10 to 130 seconds.
<HUAWEI> system-view [HUAWEI] ipv6 [HUAWEI] ospfv3 [HUAWEI-ospfv3-1] router-id 10.1.1.1 [HUAWEI-ospfv3-1] quit [HUAWEI] interface vlanif 10 [HUAWEI-Vlanif10] ipv6 enable [HUAWEI-Vlanif10] ospfv3 1 area 1 [HUAWEI-Vlanif10] ospfv3 timer poll 130
# Set the polling interval for sending Hello packets on the GE0/0/1 to 130 seconds.
<HUAWEI> system-view [HUAWEI] ipv6 [HUAWEI] ospfv3 [HUAWEI-ospfv3-1] router-id 10.1.1.1 [HUAWEI-ospfv3-1] quit [HUAWEI] interface gigabitethernet 0/0/1 [HUAWEI-GigabitEthernet0/0/1] undo portswitch [HUAWEI-GigabitEthernet0/0/1] ipv6 enable [HUAWEI-GigabitEthernet0/0/1] ospfv3 1 area 1 [HUAWEI-GigabitEthernet0/0/1] ospfv3 timer poll 130