radio-type (5G radio profile view)

Function

The radio-type command sets the radio type in a 5G radio profile.

The undo radio-type command restores the default radio type in a 5G radio profile.

By default, the radio type in a 5G radio profile is dot11ax.

Format

radio-type { dot11a | dot11n | dot11ac | dot11ax }

undo radio-type

Parameters

Parameter	Description	Value
dot11a	Specifies the 802.11a radio type.	-
dot11n	Specifies the 802.11n radio type, which is backward compatible.	-
dot11ac	Specifies the 802.11ac radio type, which is backward compatible.	-
dot11ax	Specifies the 802.11ax radio type, which is backward compatible.	-

Views

5G radio profile

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Usually, the default radio type is used and does not need to be modified. If the default radio mode cannot meet requirements or a fault needs to be located, configure the radio type as required.

Precautions

When the radio type is set to dot11a, the function of denying access from non-HT STAs becomes invalid.

If the configured radio type is not supported by an AP, the actual radio type supported by the AP takes effect. For example, if you set the 802.11ac radio type for an 802.11n AP, the 802.11n radio type takes effect on the AP.

If WDS- or Mesh-enabled radios are configured not to support 802.11n/ac, the air interface backhaul performance will be degraded.

Example

# Set the radio type to dot11n in a 5G radio profile.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] radio-5g-profile name default
[HUAWEI-wlan-radio-5g-prof-default] radio-type dot11n