reset engine session table [ source source-ip-address | destination destination-ip-address | destination-port destination-port-number | protocol { tcp | udp } ] * [ slot slot-id cpu cpu-id ]
| Parameter | Description | Value |
|---|---|---|
| source source-ip-address | Specifies the source IPv4 address. |
The value is in dotted decimal notation. |
| destination destination-ip-address | Specifies the destination IPv4 address. |
The value is in dotted decimal notation. |
| destination-port destination-port-number | Specifies the destination port number. |
The value is an integer ranging from 0 to 65535. |
| protocol | Indicates a protocol. |
- |
| tcp | Indicates Transmission Control Protocol (TCP). |
- |
| udp | Indicates User Datagram Protocol (UDP). |
- |
| slot slot-id | Specifies a slot ID. |
The value range depends on the device configuration. |
| cpu cpu-id | Specifies a CPU ID. |
The value range depends on the device configuration. |
Usage Scenario
If no parameter is specified, all session information of the engine is cleared after you run the reset engine session table command.
Prerequisites
Before running this command, you must run the defence engine enable command to enable the IAE.
Precautions
Use caution before you decide to run this command. Clearing the session information of the engine adversely affects the service operating.