restart (interface view)

Function

The restart command restarts an interface.

Format

restart

Parameters

None

Views

Ethernet interface view, GE interface view, XGE interface view, MultiGE interface view, MultiGE sub-interface view, 25GE interface view, 40GE interface view, 100GE interface view, Eth-Trunk interface view, VLANIF interface view, Sub-interface view, Tunnel interface view, VE interface view, VE sub-interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After modifying parameters of an interface, run the restart command to make the modification take effect.

Precautions

Restarting an interface during data transmission will cause data frame loss or service interruption. Exercise caution when you use the restart command.
Running the restart command is equivalent to running the shutdown command and the undo shutdown command in sequence.
Only the S5720-EI, S5720-HI, S5730-HI, S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6720-EI, S6720-HI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support sub-interfaces.

Example

# Restart GE0/0/1.

<HUAWEI> system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] restart