The route-policy-change notify-delay command sets the delay before the RM to notify each protocol of applying a new policy after the original route-policy changes.
The undo route-policy-change notify-delay command restores the default setting.
By default, this command is not configured, and the delay time is 0s.
| Parameter | Description | Value |
|---|---|---|
| delay-time | Specifies the delay for applying a new policy after the original route-policy changes. | The value is an integer ranging from 1 to 180, in seconds. |
The switch process the changes of a route-policy according to the following rules.
After the configuration of a route-policy changes, by default, the RM immediately notifies the protocol of performing related operations. To delay processing the changes of the route-policy, you can run the route-policy-change notify-delay command to set the delay for change processing. The new policy is applied after the timer expires:
If the configuration of the route-policy changes again within the delay, the RM resets the timer.
If the new policy is configured for BGP, the refresh bgp all command can be used within the delay set by the route-policy-change notify-delay command to trigger BGP to immediately use the new policy.