The snmp-agent trap enable port command enables the system to generate an alarm when the inbound or outbound bandwidth usage on all Ethernet sub-interfaces exceeds the threshold.
| Parameter | Description | Value |
|---|---|---|
| input-rate | Enables the system to generate an alarm when the inbound bandwidth usage on all Ethernet sub-interfaces exceeds the threshold. | - |
| output-rate | Enable the system to generate an alarm when the outbound bandwidth usage on all Ethernet sub-interfaces exceeds the threshold. | - |
This command is available to aid upgrade compatibility. It can only be run during the configuration restoration phase of the upgrade.
If the threshold for the inbound or outbound bandwidth usage has been configured on an Ethernet sub-interface, you can enable the system to generate an alarm when the threshold is exceeded. This allows you to determine whether the device is functioning normally.
After the configuration is complete, the system generates an alarm when the bandwidth usage exceeds or falls below the threshold.