source (BLE profile view)

Function

The source command sets the source IP address used by the AC to send packets to a location server.

The undo source command deletes the configured source IP address.

By default, the source IP address used by the AC to send packets to a location server is not configured, and the IP address of the route outbound interface is used as the source IP address.

Format

source ip-address ip-address

undo source

Parameters

Parameter	Description	Value
ip-address ip-address	Specifies the source IPv4 address used by the AC to send packets to a location server.	The value is in dotted decimal notation.

Views

BLE profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In Bluetooth location scenarios, after the source IP address used by the AC to send packets to a location server is configured using the source command, the packet sent from the AC to a location server carries this IP address as its source IP address.

Precautions

Ensure that the AC IP address manually configured on a location server is the same as that configured using the source command.
The source IP address must be a valid IP address existing on the device; otherwise, the configuration does not take effect.
When the source (BLE profile view) and ble source commands are both executed, the function configured using the source (BLE profile view) command takes effect.

Example

# Configure the source IP address of the packets sent from the AC to a location server as 10.102.25.23.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ble-profile name huawei
[HUAWEI-wlan-ble-prof-huawei] source ip-address 10.102.25.23