sta-offline-delay aging-time

Function

The sta-offline-delay aging-time command configures the aging time for STA offline delay.

The undo sta-offline-delay aging-time command restores the default aging time for STA offline delay.

The default aging time for STA offline delay is 180 seconds.

Format

sta-offline-delay aging-time time

undo sta-offline-delay aging-time

Parameters

Parameter	Description	Value
time	Specifies the aging time for STA offline delay.	The value is an integer that ranges from 1 to 86400, in seconds. The default value is 180.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After the STA offline delay function is enabled, STAs can go offline and online again in the aging time without being authenticated, reducing the load on the authentication server. You can run the sta-offline-delay aging-time command to set the aging time.

Set the aging time for STA offline delay based on the network requirements and device performance. A long aging time causes the STA offline delay function to occupy many resources, affecting new STA access. A short aging time cannot achieve a noticeable effect in releasing the load on the authentication server.

Prerequisites

The STA offline delay function has been enabled using the sta-offline-delay enable command.

Example

# Set the aging time for STA offline delay to 300s.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] sta-offline-delay enable
[HUAWEI-wlan-view] sta-offline-delay aging-time 300