stp enable (AP wired port profile view)

Function

The stp enable command enables STP on an AP's wired interface.

The undo stp enable command disables STP on an AP's wired interface.

By default, STP is disabled on an AP's wired interface.

Format

stp enable

undo stp enable

Parameters

None

Views

AP wired port profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the stp enable command to prevent or eliminate loops on a complex Layer 2 network. STP on the AP's wired interfaces takes effect only when the AP forms a single loop with wired devices. Wireless links (such as WDS or Mesh links) only transparently forward STP packets. An STP-enabled AP does not forward STP packets to the wireless side. STP takes effect only on the AP's wired side.

Precautions

The AP wired interfaces added to an Eth-Trunk do not support STP.

Example

# Enable STP on the AP's wired interface GE0.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] quit
[HUAWEI-wlan-view] wired-port-profile name wired
[HUAWEI-wlan-wired-port-wired] stp enable
[HUAWEI-wlan-wired-port-wired] quit
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] wired-port-profile wired gigabitethernet 0