DEVM_1.3.6.1.4.1.2011.5.25.219.2.2.5 hwBoardInvalid-132630

Trap Buffer Description

The board totally failed. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityType=[EntityType], EntityTrapFaultID=132630, Reason=The clock signals of the SFU fabric is abnormal.)

The overall function of the board does not take effect.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Alert
Mnemonic Code	hwBoardInvalid
Trap OID	1.3.6.1.4.1.2011.5.25.219.2.2.5
MIB	HUAWEI-ENTITY-TRAP-MIB
Alarm ID	0x0813002e
Alarm Name	hwBoardInvalid
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.219.2.2.6 hwBoardInvalidResume-132630

Trap Buffer Parameters

Parameter	Description
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntityTrapFaultID	Indicates the error code.
EntPhysicalName	Indicates the name of the entity such as a chassis.
EntityType	Indicates the type of the physical entity. The value can be one of the following: 1: mpu(1) 2: lpu(2) 3: sfu(3) 4: pic(4) 5: cfcard(5) 6: ofc(6) 7: npu(7)
Reason	Indicates the description of the cause of the trap.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.219.1.1	hwEntityPhysicalIndex	-
1.3.6.1.2.1.47.1.1.1.1.7	entPhysicalName	entPhysicalIndex
1.3.6.1.4.1.2011.5.25.219.1.2	hwEntityTrapEntType	-
1.3.6.1.4.1.2011.5.25.219.1.3	hwEntityTrapFaultID	-
1.3.6.1.4.1.2011.5.25.219.1.13	hwEntityTrapReasonDescr	-
1.3.6.1.4.1.2011.5.25.31.1.1.1.1.2	hwEntityOperStatus	entPhysicalIndex

Impact on the System

A large number of packets will be lost when the SFU forwards data.

Possible Causes

The clock signals of the SFU fabric is abnormal.

Procedure

1. Run the reset slot slot-id command to reset the faulty SFU. After the SFU is registered, check whether the alarm is cleared.

If so, go to Step 4.
If not, go to Step 2.

2. Replace the SFU and check whether the alarm is cleared.

If so, go to Step 4.
If not, go to Step 3.

3. Collect trap, log, and configuration information, and contact technical support.

4. End.