DRIVER_1.3.6.1.4.1.2011.5.25.157.2.317 hwFlexEGrpSpeedModeMismatch

Trap Buffer Description

The speed modes of the FlexE physical interfaces in the FlexEGroup mismatch alarm.(GroupIndex=[hwFlexEGroupIndex],GroupName=[hwFlexEGroupName])

The speed modes of the FlexE physical interfaces in the FlexEGroup mismatch alarm.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Critical
Mnemonic Code	hwFlexEGrpSpeedModeMismatch
Trap OID	1.3.6.1.4.1.2011.5.25.157.2.317
MIB	HUAWEI-PORT-MIB
Alarm ID	0x080122a4
Alarm Name	hwFlexEGrpSpeedModeMismatch
Alarm Type	communicationsAlarm
Raise or Clear	Raise
Match trap	DRIVER_1.3.6.1.4.1.2011.5.25.157.2.318 hwFlexEGrpSpeedModeMismatchResume

Trap Buffer Parameters

Parameter	Description
hwFlexEGroupIndex	Index of FlexE group.
hwFlexEGroupName	Name of FlexE Group.This parameter specifies the slot and card informations and group index which the group belongs.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.157.1.30.5	hwFlexEGroupIndex	-
1.3.6.1.4.1.2011.5.25.157.1.30.6	hwFlexEGroupName	-

Impact on the System

Services on the interface are affected.

Possible Causes

The rates of the physical interfaces bound to the FlexE group are different.

Procedure

1. Check whether the bandwidths of the FlexE physical interfaces in the FlexE group are the same.

If so, go to Step 5.
If not, go to Step 2.

2. Check whether the FlexE physical interfaces in the group support forcible switchover or auto-sensing.

If the interfaces support forcible switchover, auto-sensing, or both, go to Step 3.
If the interfaces support neither forcible switchover nor auto-sensing, go to Step 4.

3. Run the port-speed command or insert an optical module to ensure that the bandwidths of the FlexE physical interfaces in the group are the same. Then check whether the alarm is cleared.

If so, go to Step 6.
If not, go to Step 4.

4. Re-select physical interfaces and bind them in the group to ensure that the bandwidths of the physical interfaces are the same. Then, check whether the alarm is cleared.

If so, go to Step 6.
If not, go to Step 5.

5. Collect alarm, log, and configuration information, and contact technical support personnel.

6. End.