APS reported an alarm about the mismatch of the working and protection paths. (PwApsId=[PwApsId], PWID=[PWID], PWTYPE=[PWTYPE], PWPeerIp=[PWPeerIp], PwIndex=[PwIndex])
Information about the working and protection paths in the APS packet sent from the remote end was inconsistent with that on the local end.
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Error |
Mnemonic Code |
hwPwApsPathMismatch |
Trap OID |
1.3.6.1.4.1.2011.5.25.119.10.2.3 |
MIB |
HUAWEI-L2VPN-PW-APS-MIB |
Alarm ID |
0x0000332c |
Alarm Name |
hwPwApsPathMismatch |
Alarm Type |
communicationsAlarm |
Raise or Clear |
Raise |
Match trap |
L2VPN_1.3.6.1.4.1.2011.5.25.119.10.2.4 hwPwApsPathMismatchClear |
| Parameter | Description |
|---|---|
PwApsId |
ID of the PW APS instance |
PWID |
ID of the PW |
PWTYPE |
PW encapsulation type |
PWPeerIp |
Destination address of the PW |
PwIndex |
Interface index of the PW |
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.5.25.119.10.1.1.1.1 |
hwPwApsId |
hwPwApsId |
1.3.6.1.4.1.2011.5.25.119.4.1.7.1.1.4 |
hwPWInterfaceIndex |
hwPWId hwPWType hwPWPeerIp |
1. Run the display this command on the AC (sub-)interface of the CSG to view the PW state (primary or secondary) and on the AC (sub-)interface of the RSG to view the PW state (primary or backup) to check if the configurations on the two ends of each PW match.
2. Reconfigure the primary, secondary, and bypass PWs on the CSG and RSG and check whether the alarm is cleared.
3. Collect alarm information and configuration information, and then contact technical support personnel.
4. End.