The public network tunnel to which the VLL service is diverted does not support traffic forwarding. (InterfaceName=[hwVLLACPortName], RemoteIP=[hwVLLPeerRemoteIp], TunnelType=[hwNotSupportTunnelType])
A VLL service with VPN QoS configured is diverted to an unsupported public network tunnel.
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Warning |
Mnemonic Code |
hwVllVpnQosNotSupportTunnelAlarm |
Trap OID |
1.3.6.1.4.1.2011.5.25.42.2.1.7.55 |
MIB |
HUAWEI-L2MAM-MIB |
Alarm ID |
0x00F101f5 |
Alarm Name |
hwVllVpnQosNotSupportTunnelAlarm |
Alarm Type |
qualityOfServiceAlarm |
Raise or Clear |
Raise |
Match trap |
L2VPN_1.3.6.1.4.1.2011.5.25.42.2.1.7.56 hwVllVpnQosNotSupportTunnelAlarmResume |
| Parameter | Description |
|---|---|
hwVLLACPortName |
VLL AC interface. |
hwVLLPeerRemoteIp |
VLL remote peer IP address. |
hwNotSupportTunnelType |
Tunnel type. |
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.5.25.42.2.1.52.1.1 |
hwVLLACIfName |
hwVLLACIfName hwVLLPeerRemoteIp hwNotSupportTunnelTypeName |
1.3.6.1.4.1.2011.5.25.42.2.1.52.1.2 |
hwVLLPeerRemoteIp |
hwVLLACIfName hwVLLPeerRemoteIp hwNotSupportTunnelTypeName |
1.3.6.1.4.1.2011.5.25.42.2.1.47 |
hwNotSupportTunnelType |
- |
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
The VLL service with VPN QoS configured cannot be forwarded through the current public network tunnel.
After VPN QoS is configured for VLL, the TE over GRE public network tunnel does not support traffic forwarding.
1. Locate the interface based on the AC interface name in the alarm. Run the display this command in the interface view to check the bound tunnel policy. In the tunnel policy view, run the tunnel select-seq lsp load-balance-number command to change the tunnel to another type of tunnel. Then check whether the alarm is cleared.
2. Collect the trap information, log information, and configuration information, and then contact technical support personnel.
3. End.