LACP_1.3.6.1.4.1.2011.5.25.41.3.58 hwLacpStateDown

Trap Buffer Description

The LACP status of the member port changes to down. (TrunkIndex=[TrunkIndex],PortIfIndex=[PortIfIndex],TrunkId=[TrunkId],TrunkName=[TrunkName],PortName=[PortName],Reason=[ReasonCode])

The LACP status of the member interface is Down.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Critical
Mnemonic Code	hwLacpStateDown
Trap OID	1.3.6.1.4.1.2011.5.25.41.3.58
MIB	HUAWEI-IF-EXT-MIB
Alarm ID	0x09362015
Alarm Name	hwLacpStateDown
Alarm Type	communicationsAlarm
Raise or Clear	Raise
Match trap	LACP_1.3.6.1.4.1.2011.5.25.41.3.59 hwLacpStateDownResume

Trap Buffer Parameters

Parameter	Description
TrunkIndex	Trunk index
PortIfIndex	Index of a member port
TrunkId	Trunk interface ID
TrunkName	Trunk interface name
PortName	Member port name
ReasonCode	Cause of the alarm

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.41.1.3.3.1.2	hwTrunkIfID	hwTrunkIndex
1.3.6.1.2.1.31.1.1.1.1	ifName	ifIndex
1.3.6.1.2.1.31.1.1.1.1	ifName	ifIndex

Procedure

1. Run the display this command in the interface view to check whether the interfaces at both ends are shut down.

If the interfaces are shut down, run the undo shutdown command to enable the interfaces. Then, check whether the alarm is cleared. If the alarm persists, go to Step 2.
If the interfaces are not shut down, go to Step 2.

2. Check whether the physical connection is normal. For example, check whether the network cable or optical module is loose or disconnected.

If the physical link is abnormal, reconnect the physical link and check whether the alarm is cleared. If the alarm persists, go to Step 3.
If the physical link is normal, go to Step 3.

3. Run the display interface eth-trunk command in the system view to check whether an interface on the local or peer device is removed from the Eth-Trunk.

If the interface is removed from the Eth-Trunk abnormally, run the eth-trunk command in the member interface view or run the trunkport command in the Eth-Trunk interface view to add the interface to the Eth-Trunk again. Then, check whether the alarm is cleared. If the alarm persists, go to Step 4.
If the interface is removed from the Eth-Trunk, go to Step 4.

4. Collect alarm, log, and configuration information, and contact technical support personnel.