LDT_1.3.6.1.4.1.2011.25.180.2.9 hwAutoLoopDetectTriggerDown

Trap Buffer Description

The interface turned to trigger-down state,because of the loop detected on this interface. (Interface=[IfName], VlanId=[VlanId], InstName=[vsi_name])

The interface turned to the trigger-down state because a loop was detected on this interface.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Buffer Parameters

VB Parameters

Procedure

• Cause 1: A loop was detected on the interface that has proactive loop detection enabled after it went Up. The interface was then blocked.

  1.Run the display loop-detect trigger trigger-down all command to check whether there is an interface in the trigger-down state.

  • If so, go to Step 2.
  • If not, go to Step 4.

  2.Check whether the interface connection has a loop.

  • If so, go to Step 3.
  • If not, go to Step 4.

  3.After removing the interface loop, run the reset loop-detect trigger trigger-down command to unblock the interface, and check whether the alarm is released.

  • If so, go to Step 5.
  • If not, go to Step 4.

  4.Collect alarm information, log information and configuration information, and then contact technical support personnel.

  5.End.

• Cause 2: A loop was detected on the interface that has proactive loop detection enabled after it went Up.

  1.Run the display loop-detect trigger trigger-down all command to check whether there is an interface in the trigger-down state.

  • If so, go to Step 2.
  • If not, go to Step 3.

  2.Check whether loops occur on the interface and the Layer 2 network connected to the interface.

  • If so, go to Step 4.
  • If not, go to Step 3.

  3.Collect trap, log, and configuration information, and contact technical support personnel.

  4.End.