The IPv4 vxlan tunnel status changes. (SourceIpAddress=[SrcIpAddr], DestinationIpAddress=[DstIpAddr], TunnelStatus=[TnlStatus])
The IPv4 VXLAN tunnel status changed.
In VS mode, this trap is supported only by the admin VS.
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Critical |
Mnemonic Code |
IPv4VxlanTunnelDown |
Trap OID |
1.3.6.1.4.1.2011.5.25.335.6.5 |
MIB |
HUAWEI-NVO3-MIB |
Alarm ID |
0x0a112005 |
Alarm Name |
IPv4VxlanTunnelDown |
Alarm Type |
equipmentAlarm |
Raise or Clear |
Raise |
Match trap |
| Parameter | Description |
|---|---|
SrcIpAddr |
Source VTEP address of an IPv4 VXLAN tunnel. |
DstIpAddr |
Remote VTEP address of an IPv4 VXLAN tunnel. |
TnlStatus |
IPv4 VXLAN tunnel status. |
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.5.25.335.1.3.1.3 |
hwNvo3VxlanTnlStatus |
hwNvo3VxlanTnlSrcAddress hwNvo3VxlanDestAdress |
1. Run the display ip routing-table command to check whether the source and destination IPv4 addresses of the IPv4 VXLAN tunnel are reachable.
2. Configure a static or dynamic route so that the source and destination IPv4 addresses of the IPv4 VXLAN tunnel are reachable. Then run the display vxlan tunnel command to check whether the IPv4 VXLAN tunnel goes up.
3. Collect log and configuration information, and contact Huawei technical support personnel.
4. End.