SYSTEM_1.3.6.1.4.1.2011.5.25.219.2.11.1 hwSystemConfigError-144130

Trap Buffer Description

A system configuration error occurs. ( EntityTrapFaultID = [EntityTrapFaultID])

The system configuration is incorrect.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Critical
Mnemonic Code	hwSystemConfigError
Trap OID	1.3.6.1.4.1.2011.5.25.219.2.11.1
MIB	HUAWEI-ENTITY-TRAP-MIB
Alarm ID	0x0D300004
Alarm Name	hwSystemConfigError
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	SYSTEM_1.3.6.1.4.1.2011.5.25.219.2.11.2 hwSystemConfigResume-144130

Trap Buffer Parameters

Parameter	Description
EntityTrapFaultID	Trap error code: 144128: The PAF version is inconsistent with the version of the startup software package. 144129: The boards and subcards of the device are not inserted into the corresponding slots. 144130: The versions of the active and standby main control boards are inconsistent. 144133: The memory of the active main control board is inconsistent with that of the standby main control board. 144134: The PTN startup mode does not match the mode selected during license activation.

Parameter

Description

EntityTrapFaultID

Trap error code:

144128: The PAF version is inconsistent with the version of the startup software package.
144129: The boards and subcards of the device are not inserted into the corresponding slots.
144130: The versions of the active and standby main control boards are inconsistent.
144133: The memory of the active main control board is inconsistent with that of the standby main control board.
144134: The PTN startup mode does not match the mode selected during license activation.

VB Parameters

None

Impact on the System

If the PAF version is inconsistent with the version of the startup software package, the PAF file carried in the startup software package is started.
When the versions of the active and standby main control boards are inconsistent, the standby main control board cannot be started.
If the startup mode (dcn-management-plane or dcn-control-plane mode) does not match the mode selected during license activation, services in the mode selected during license activation may not take effect.

Possible Causes

The software versions on the master and slave control boards are inconsistent.

Procedure

The versions of the active and standby boards are inconsistent.

1. Run the startup system-software command to change the version of the slave board to be the same as that of the master board. Then, run the reset slot command to reset the slave board.

If the alarm is cleared, go to Step 3.
If the alarm persists, go to Step 2.

2. Collect alarm and configuration information, and contact technical support personnel.

3. No further action is required.