BRASAM_1.3.6.1.4.1.2011.6.8.2.2.0.9 hwPoolGroupUsedIPReachThreshold
Trap Buffer Description
The number of IP addresses in the IP pool group exceeds the threshold. (PoolGroupNo.=[PoolGroupNo],PoolGroupName=[PoolGroupName])
The proportion of the consumed addresses in an address pool group to the total number of addresses was above the preset threshold, which is 80% by default.
In VS mode, this trap is supported only by the admin VS.
Trap Attributes
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Warning |
Mnemonic Code |
hwPoolGroupUsedIPReachThreshold |
Trap OID |
1.3.6.1.4.1.2011.6.8.2.2.0.9 |
MIB |
HUAWEI-IPPOOL-MIB |
Alarm ID |
0x0ae9200a |
Alarm Name |
hwPoolGroupUsedIPReachThreshold |
Alarm Type |
equipmentAlarm |
Raise or Clear |
Raise |
Match trap |
BRASAM_1.3.6.1.4.1.2011.6.8.2.2.0.10 hwPoolGroupUsedIPReachThresholdResume |
Trap Buffer Parameters
| Parameter | Description |
|---|---|
PoolGroupNo |
Index ID of an address pool group. |
PoolGroupName |
Name of the address pool group. |
VB Parameters
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.6.8.2.1.4 |
hwIPPoolGroupIndex |
- |
1.3.6.1.4.1.2011.6.8.1.10.1.1 |
hwIPPoolGroupName |
hwIPPoolGroupName |
Procedure
1.Run the ip-pool command in the relevant pool group view to bind a pool with a large number of idle addresses, or run the section section-num start-ip-address [ end-ip-address ] command to increase the number of addresses in the pool, and then check whether the alarm is cleared.
- If so, go to Step 3.
- If not, go to Step 2.
2.Collect alarm information, log information, and configuration information, and contact technical support personnel.
3.End.