BRASEAP_1.3.6.1.4.1.2011.5.25.40.4.3.2.0.1 hwEapUserPortMaxNum

Trap Buffer Description

The number of EAP user resources on the interface reaches the upper threshold.(ifIndex=[ifIndex],ifDescr=[ifDescr],hwEapUserPortMaxNumThreshold=[hwEapUserPortMaxNumThreshold] )

The number of EAP user resources on the interface reaches the upper threshold.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Warning
Mnemonic Code	hwEapUserPortMaxNum
Trap OID	1.3.6.1.4.1.2011.5.25.40.4.3.2.0.1
MIB	HUAWEI-BRAS-SRVCFG-EAP-MIB
Alarm ID	0x08b92001
Alarm Name	hwEapUserPortMaxNum
Alarm Type	qualityOfServiceAlarm
Raise or Clear	Raise
Match trap	BRASEAP_1.3.6.1.4.1.2011.5.25.40.4.3.2.0.2 hwEapUserPortMaxNumResume

Trap Buffer Parameters

Parameter	Description
ifIndex	Port index
ifDescr	Port information
hwEapUserPortMaxNumThreshold	Upper threshold

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.2.1.2.2.1.2	ifDescr	ifIndex
1.3.6.1.4.1.2011.5.25.40.4.3.1.1	hwEapUserPortMaxNumThreshold	-

Impact on the System

If the problem remains unresolved, user resources on the interface may be exhausted, and new dial-in users may fail to go online.

Possible Causes

The upper threshold for the maximum number of users supported on the interface was too small.

Procedure

1. Run the display dot1x interface command in the system view to check whether the alarm threshold is too small.

If the alarm threshold is too small, go to Step 2.
If the alarm threshold is not too small, go to Step 3.

2. Reconfigure a proper upper threshold for the maximum number of users supported on the device.

If the upper threshold is successfully reconfigured, go to step 5.
If the upper threshold is not successfully reconfigured, go to step 4.

3. Run the display dot1x interface command in the system view to check the number of current users. If the number of users is close to the maximum number of users supported on the device, add an interface board or contact technical support engineers.

If the number of users is not close to the maximum number of users supported on the device, go to Step 5.
If the number of access users is close to the maximum number of users supported on the device, go to Step 4.

4. Collect alarm, log, and configuration information, and contact technical support personnel.

5. End.