DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.1 hwEntityRemove-65538

Trap Buffer Description

Physical entity is removed.(BaseTrapSeverity=1, BaseTrapProbableCause=65538, BaseTrapEventType=5, EntityPhysicalIndex=[ULONG], EntPhysicalContainedIn=[ULONG], EntPhysicalName=cfcard1(cfcard2) <slotID>, Reason=Cfcard1(Cfcard2) is Removed.)

Physical entity is removed.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Alert
Mnemonic Code	hwEntityRemove
Trap OID	1.3.6.1.4.1.2011.5.25.129.2.1.1
MIB	HUAWEI-BASE-TRAP-MIB
Alarm ID	0x08130098
Alarm Name	hwEntityRemove
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.129.2.1.2 hwEntityInsert-65538

Trap Buffer Parameters

Parameter	Description
BaseTrapSeverity	Indicates the severity level of the trap reported to the NMS.
BaseTrapProbableCause	Indicates the possible cause of the trap.
BaseTrapEventType	Indicates the trap type.
EntityPhysicalIndex	Indicates the physical index.
EntPhysicalContainedIn	Indicates the parent index.
EntPhysicalName	Indicates the name of the entity such as a chassis.
Reason	Reason.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.129.1.1	hwBaseTrapSeverity	-
1.3.6.1.4.1.2011.5.25.129.1.2	hwBaseTrapProbableCause	-
1.3.6.1.4.1.2011.5.25.129.1.3	hwBaseTrapEventType	-
1.3.6.1.2.1.47.1.1.1.1.4	entPhysicalContainedIn	entPhysicalIndex
1.3.6.1.2.1.47.1.1.1.1.7	entPhysicalName	entPhysicalIndex

Impact on the System

The services are not affected temporarily; however, the log information on the board cannot be recorded or saved. If the board type is MPUA, the board cannot be registered after it is reset.

Possible Causes

The CF card was removed.

Procedure

1.Check whether the CF card needs to be inserted into the board.

If the CF card needs to be inserted into the board, go to Step 2.
If the CF card does not need to be inserted into the board, clear the alarm. Then, go to Step 4.

2.Insert the CF card into the corresponding slot on the MPU. Then, check whether the alarm is cleared.

If the alarm is cleared, go to Step 4.
If the alarm is not cleared, go to Step 3.

3.Collect the trap information, log information, and configuration information, and contact technical support personnel.

4.End.