DEVM_1.3.6.1.4.1.2011.5.25.219.2.5.1 hwPowerRemove-136448

Trap Buffer Description

A power module was removed. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityTrapFaultID=136448, Reason=The power module was removed.)

A power module was removed.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Alert
Mnemonic Code	hwPowerRemove
Trap OID	1.3.6.1.4.1.2011.5.25.219.2.5.1
MIB	HUAWEI-ENTITY-TRAP-MIB
Alarm ID	0x0813001f
Alarm Name	hwPowerRemove
Alarm Type	equipmentAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.219.2.5.2 hwPowerInsert-136448

Trap Buffer Parameters

Parameter	Description
EntityPhysicalIndex	The index for this entry.
EntPhysicalIndex	The index for this entry.
EntityTrapFaultID	To describe the fault id of trap.
EntPhysicalName	The textual name of the physical entity.
Reason	Reson.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.219.1.1	hwEntityPhysicalIndex	-
1.3.6.1.2.1.47.1.1.1.1.7	entPhysicalName	entPhysicalIndex
1.3.6.1.4.1.2011.5.25.219.1.3	hwEntityTrapFaultID	-
1.3.6.1.4.1.2011.5.25.31.1.1.1.1.2	hwEntityOperStatus	entPhysicalIndex

Impact on the System

A power failure may cause the insufficient power supply of the router. If the supply is insufficient, there will be a lot of confusing problems, such as board resetting due to heartbeat packet loss. Such problems indirectly affect services and need to be resolved.

Possible Causes

The power module was removed.

Procedure

1.Check whether the power supply module is installed.

If so, check whether the power supply module is installed securely. Then, go to Step 2.
If not, install the power supply module.

2.If the alarm persists, replace the power supply module.

3.If the alarm still exists, collect trap, log, and configuration information, and contact technical support personnel.

4.End.