DEVM_1.3.6.1.4.1.2011.5.25.41.4.5 hwIfMonitorInputRateRising

Trap Buffer Description

Interface input flow bandwidth usage exceeded the trap threshold. (Interface=[IfIndex], BandWidthUsage=[hwSubIfInputRatePercentage], TrapThreshold=[hwSubIfInputRateThreshold], InterfaceName=[InterfaceName])

Interface input flow bandwidth usage exceeded the trap threshold.

In VS mode, this trap is supported only by the admin VS.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Alarm
Trap Severity	Warning
Mnemonic Code	subIfInputRateRising
Trap OID	1.3.6.1.4.1.2011.5.25.41.4.5
MIB	HUAWEI-IF-EXT-MIB
Alarm ID	0x081300ae
Alarm Name	hwIfMonitorInputRateRising
Alarm Type	processingErrorAlarm
Raise or Clear	Raise
Match trap	DEVM_1.3.6.1.4.1.2011.5.25.41.4.6 hwIfMonitorInputRateResume

Trap Buffer Parameters

Parameter	Description
IfIndex	Interface index .
hwSubIfInputRatePercentage	Input flow bandwidth usage.
hwSubIfInputRateThreshold	Trap threshold.
InterfaceName	Interface name.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.5.25.41.1.7.1.1.8	hwIfMonitorInputRate	hwIfMonitorIndex
1.3.6.1.4.1.2011.5.25.41.1.7.1.1.9	hwIfMonitorInputRateThreshold	hwIfMonitorIndex
1.3.6.1.4.1.2011.5.25.41.1.7.1.1.19	hwIfMonitorName	hwIfMonitorIndex

Impact on the System

Discarding packets may happen when the interface input flow bandwidth usage is 100%

Possible Causes

Interface input flow bandwidth usage exceeded the trap threshold.

Procedure

1.Run the display this interface command in the interface view to check whether the traffic volume threshold is proper for the actual service conditions.

If the threshold is too low, go to Step 2.
If the threshold is proper, go to Step 3.

2.Run the trap-threshold input-rate threshold_value command in the interface view to set a proper alarm threshold. Then, check whether the alarm is cleared.

If the alarm is cleared, go to Step 4.
If the alarm persists, go to Step 3.

3.Collect the trap, log, and configuration information, and then contact technical support personnel.

4.End.