NAT_1.3.6.1.4.1.2011.5.25.240.2.38 hwCGNUserTableThresholdAlarm
Trap Buffer Description
The number of user tables reached the upper limit. (UserTableNum=[UserTableNum],Threshold=[Threshold],Slot=[Slot], Cpu=[Cpu])
The number of NAT user tables reached the threshold.
In VS mode, this trap is supported only by the admin VS.
Trap Attributes
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Warning |
Mnemonic Code |
hwCGNUserTableThresholdAlarm |
Trap OID |
1.3.6.1.4.1.2011.5.25.240.2.38 |
MIB |
HUAWEI-DSLITE-MIB |
Alarm ID |
0x00F1001c |
Alarm Name |
hwCGNUserTableThresholdAlarm |
Alarm Type |
communicationsAlarm |
Raise or Clear |
Raise |
Match trap |
NAT_1.3.6.1.4.1.2011.5.25.240.2.39 hwCGNUserTableThresholdResumeAlarm |
Trap Buffer Parameters
| Parameter | Description |
|---|---|
UserTableNum |
Number of user tables that are used. |
Threshold |
Threshold of the proportion of used user tables to the total supported ones. |
Slot |
Slot ID of a service board. |
Cpu |
CPU ID of the service board. |
VB Parameters
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.5.25.240.1.2.18 |
hwCGNAlarmUserTableNum |
- |
1.3.6.1.4.1.2011.5.25.240.1.2.8 |
hwVSUAlarmThreshold |
- |
1.3.6.1.4.1.2011.5.25.240.1.2.10 |
hwVSUAlarmSlot |
- |
1.3.6.1.4.1.2011.5.25.240.1.2.11 |
hwVSUAlarmCpu |
- |
Procedure
1.Run the display nat user-information command. Then check the information of NAT users whether the proportion of used NAT user tables reaches the specified threshold.
- If the proportion reaches the specified threshold, go to Step 2.
- If the proportion does not reach the specified threshold, go to Step 3.
2.Run the nat alarm user-table threshold command in the system view to increase the threshold. Check whether the trap is cleared.
- If the trap is cleared, go to Step 4.
- If the trap persists, go to Step 3.
3.Collect trap, log, and configuration information, and then contact technical support personnel.
4.End.