mpls lsr-id

Function

The mpls lsr-id command sets the ID of an LSR.

The undo mpls lsr-id command deletes the ID of an LSR.

By default, no ID is configured for an LSR.

Format

mpls lsr-id lsr-id

undo mpls lsr-id

Parameters

Parameter Description Value
lsr-id

Specifies the ID of an LSR. The LSR ID is used to identify an LSR.

The LSR ID is in dotted decimal notation.

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name Operations
mpls-base write

Usage Guidelines

Usage Scenario

On a network where MPLS services are deployed, you must configure the LSR IDs for devices.

An LSR does not have a default ID, and you must configure an ID for it.

It is recommended that the address of a loopback interface on an LSR be configured as the LSR ID.

Follow-up Procedure

You can configure MPLS and associated services.

Precautions

The undo mpls lsr-id command deletes existing LDP sessions and LSPs over the sessions. Execute caution when running this command.

If the mpls lsr-id command is run and the LSR ID is the same as the primary IP address of a loopback interface, note that:

  • The loopback interface cannot be bound to an L3VPN instance.
  • The loopback interface cannot be deleted.
  • The primary IP address of the loopback interface cannot be deleted or modified.

Example

# Set the ID of an LSR to 1.1.1.1.
<HUAWEI> system-view
[~HUAWEI] mpls lsr-id 1.1.1.1
Parent Topic: MPLS LDP Configuration Commands
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >