display cpu-usage service
Function
The display cpu-usage service command displays information about the CPU usage based on service types.
Usage Guidelines
Usage Scenario
To view information about the CPU usage for routine maintenance or troubleshooting a device failure, run the display cpu-usage service command.
If slot is specified, information about the CPU usage of a specified interface board is displayed.
Precautions
This command is supported only on the admin VS.
If the device starts with only basic configurations and the CPU usage is constantly higher than the alarm threshold (you can configure the alarm threshold), the CPU works abnormally. You should check the device and locate the fault.
Example
The actual command output varies according to the device. The command output here is only an example.
<HUAWEI> display cpu-usage service
Cpu utilization statistics at 2020-02-19 08:21:54 742 ms
System cpu use rate is : 2%
---------------------------
ServiceName UseRate
---------------------------
SYSTEM 2%
LOCAL PKT 0%
CMF 0%
DEVICE 0%
IP STACK 0%
TNLM 0%
RM 0%
VLAN 0%
SLA 0%
FIBM 0%
ND 0%
OAM 0%
ARP 0%
FIBRESM 0%
IFM 0%
TUNNEL 0%
---------------------------
| Item | Description |
|---|---|
| Cpu utilization statistics at 2020-02-19 08:21:54 742 ms | Time when the CPU usage status information is obtained. |
| System cpu use rate | System cpu use rate. |
| ServiceName | Service name. |
| UseRate | CPU usage. |