te link-attribute-application flex-algo

Function

The te link-attribute-application flex-algo command creates and displays the Flex-Algo link attribute application view.

The undo te link-attribute-application flex-algo command cancels the configuration.

By default, Flex-Algo link attribute is set by IGP.

Format

te link-attribute-application flex-algo

undo te link-attribute-application flex-algo

Parameters

None

Views

100ge sub-interface view, 100GE interface view, 10GE sub-interface view, 10GE interface view, 25GE sub-interface view, 25GE interface view, 400GE sub-interface view, 400GE interface view, 40GE sub-interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk sub-interface view, Eth-Trunk interface view, GE optical interface view, GE sub-interface view, GE electrical interface view, GMPLS-UNI interface view, Tunnel interface view, XGE sub-interface view, XGE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
mpls-te	write

Usage Guidelines

Usage Scenario

To create a Flex-Algo link attribute application view on an interface, run the te link-attribute-application flex-algo command. After this configuration, you can configure detailed link attributes for Flex-Algo services in this view.

Example

# Enter the Flex-Algo link attribute application view.

<HUAWEI> system-view
[~HUAWEI] te attribute enable
Warning: This operation will switch all TE common attributes configurations to TE mode. Continue? [Y/N]:Y
[*HUAWEI] interface GigabitEthernet0/1/0
[*HUAWEI-GigabitEthernet0/1/0] te link-attribute-application flex-algo