The c-multicast signaling command configures the signaling protocol for transmitting C-multicast routes.
The undo c-multicast signaling command deletes the signaling protocol for transmitting C-multicast routes.
By default, no signaling protocol is configured for transmitting C-multicast routes.
Usage Scenario
In a IPv6 next-generation multicast virtual private network (IPv6 NG MVPN), PIM is not configured on the public network, and therefore the receiver provider edge (PE) converts the received PIM Join/Prune messages or MLD Join message from the VPN to C-multicast routes and sends the routes to the sender PE. To configure the signaling protocol for transmitting C-multicast routes, run the c-multicast signaling command.
Precautions
Only BGP can be used as the signaling protocol for transmitting C-multicast routes.
<HUAWEI> system-view [~HUAWEI] multicast ipv6 mvpn 2.2.2.2 [*HUAWEI] ip vpn-instance mcast1 [*HUAWEI-vpn-instance-mcast1] ipv6-family [*HUAWEI-vpn-instance-mcast1-af-ipv6] route-distinguisher 22:1 [*HUAWEI-vpn-instance-mcast1-af-ipv6] multicast ipv6 routing-enable [*HUAWEI-vpn-instance-mcast1-af-ipv6] mvpn [*HUAWEI-vpn-instance-mcast1-af-ipv6-mvpn] c-multicast signaling bgp