mpls te physical-interface bandwidth-auto-config disable

Function

The mpls te physical-interface bandwidth-auto-config disable command disables automatic bandwidth configuration on physical interfaces.

The undo mpls te physical-interface bandwidth-auto-config disable command enables automatic bandwidth configuration on physical interfaces.

This command varies in transport and router modes. For detailed differences, see Differences Between Commands in Transport and Router Modes. This topic describes the command configuration in router mode.

By default, automatic bandwidth configuration on physical interfaces is enabled.

Format

mpls te physical-interface bandwidth-auto-config disable

undo mpls te physical-interface bandwidth-auto-config disable

Parameters

None

Views

MPLS view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
mpls-te	write

Usage Guidelines

Usage Scenario

After automatic bandwidth configuration is enabled on a physical interface, the device performs bandwidth configuration based on the actual bandwidth of the physical interface. If automatic bandwidth configuration is disabled for a physical interface, the device uses the bandwidth 0 instead of the actual bandwidth when the NMS delivers the TE bandwidth of the physical interface.

Precautions

The mpls te physical-interface bandwidth-auto-config disable command is supported only in transport mode.

Example

# Disable automatic bandwidth configuration on a physical interface.

<HUAWEI> system-view
[~HUAWEI] mpls
[*HUAWEI-mpls] mpls te
[*HUAWEI-mpls] mpls te physical-interface bandwidth-auto-config disable