access-speed adjustment system-state
Function
The access-speed adjustment system-state enable command configures the device to adjust the user access rate based on the system status.
The access-speed adjustment system-state disable command configures the device does not adjust the user access rate based on the system status..
By default, the device adjusts the user access rate based on the system status enabling strict check.
This command is supported only on the NetEngine 8000 F1A.
Parameters
| Parameter | Description | Value |
|---|---|---|
| strict-check |
Enables strict check, which allows the device to check the usages of access-queue, ppp-cpcar-drop, ppp-send-queue, and ppp-receive-queue. The device decreases the user access rate if the usage of any of these parameters is high. |
- |
| strict-check-l2tp |
Enables strict-check-l2tp. |
- |
Usage Guidelines
Usage Scenario
When the Router is not in a proper state, for example, the CPU or memory usage reaches 80%, run the access-speed adjustment system-state command so that the user access rate will be decreased.
Configuration Impact
The Router automatically adjusts the user access rate based on the CPU and memory usage of the main control boards and interface boards. When the CPU or memory usage of a main control board or interface board goes high, the Router decreases the user access rate. When the CPU or memory usage of a main control board or interface board restores, the Router increases the user access rate.
Precautions
In VS mode, this command is supported only by the admin VS.
You are not advised to run the access-speed adjustment system-state disable command to disable the system from adjusting the user access rate based on system status.