accounting-start-delay ipv4 start-accounting immediately
Function
The accounting-start-delay ipv4 start-accounting immediately command enables a device to send an accounting-start packet immediately after a dual-stack user goes online through the IPv4 stack.
The undo accounting-start-delay ipv4 start-accounting immediately command restores the default configuration.
By default, a device is not enabled to send an accounting-start packet immediately after a dual-stack user goes online through the IPv4 stack in the accounting-start delay scenario.
This command is supported only on the NetEngine 8000 F1A.
Usage Guidelines
Usage Scenario
If a delay is configured for the sending of dual-stack users' accounting-start packets, a device sends an accounting-start packet after both stack addresses are assigned. If you want the device to send an accounting-start packet immediately after a user goes online through the IPv4 stack, run the accounting-start-delay ipv4 start-accounting immediately command. The accounting-start packet carries the IPv4 address assigned to the user. However, if the user goes online through the IPv6 stack first, the device waits for the user to go online through the IPv4 stack or the specified accounting-start delay to expire, and then sends an accounting-start packet.
Prerequisites
The accounting-start-delay command has been run to delay the sending of accounting-start packets.
Example
<HUAWEI> system-view [~HUAWEI] aaa [~HUAWEI-aaa] domain domain1 [*HUAWEI-aaa-domain-domain1] accounting-start-delay ipv4 start-accounting immediately