site default

Function

The site default command displays the default VSI-BGP-SITE view.

By default, no VSI-BGP-SITE view is displayed.

Format

site default

Parameters

None

Views

VSI-BGP-MH view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
l2vpn	write

Usage Guidelines

Usage Scenario

In VPLS multi-homing scenarios where a CE is single-homed to a PE, after the pwsignal bgp multi-homing command is run, the system automatically generates a default multi-homing site for the single-homed PE. After the default multi-homing site is generated, run the site default command to enter the default VSI-BGP-SITE view.

Prerequisites

VPLS multi-homing has been enabled using the pwsignal bgp multi-homing command.
An RD has been configured for the VSI using the route-distinguisher (VSI-BGP view) command.

Follow-up Procedure

Run the site-id site-id command to configure a multi-homing site ID.

Precautions

The site default command applies only to VPLS multi-homing scenarios where a CE is single-homed to a PE.

The active delay-time, and recover delay-time commands used for configuring link protection between the CE and PE cannot be used.
Because only one multi-homing site exists, the best-site command cannot be used.

Example

# Display the default VSI-BGP-SITE view.

<HUAWEI> system-view
[~HUAWEI] mpls
[*HUAWEI-mpls] quit
[*HUAWEI] mpls l2vpn
[*HUAWEI-l2vpn] quit
[*HUAWEI] vsi vsi1
[*HUAWEI-vsi-vsi1] pwsignal bgp multi-homing
[*HUAWEI-vsi-vsi1-bgp] route-distinguisher 192.168.1.1:1
[*HUAWEI-vsi-vsi1-bgp] site default