bgp over ipoe enable

Function

The bgp over ipoe enable command enables BGP route forwarding between a CPE and BRAS.

The undo bgp over ipoe enable command disables BGP route forwarding between a CPE and BRAS.

By default, BGP route forwarding is disabled between a CPE and BRAS.

This command is supported only on the NetEngine 8000 F1A.

Format

bgp over ipoe enable

undo bgp over ipoe enable

Parameters

None

Views

AAA view

Default Level

3: Management level

Task Name and Operations

Task Name	Operations
aaa	write

Usage Guidelines

Usage Scenario

After a CPE uses ipoe dialup to obtain an IP address from a BRAS, the CPE can use the IP address to establish a BGP connection with the BRAS, and the BRAS can learn the BGP route from the CPE. However, traffic cannot be forwarded through the BGP route. To allow BGP route forwarding between a CPE and BRAS, run the bgp over ipoe enable command.

Configuration Impact

After this command is run, access user information is added to information about the BGP routes with the next hops being the IP addresses of IPoE users, allowing traffic to be forwarded through the BGP route between the CPE and BRAS.

Precautions

This command is supported only on the admin VS.

This command applies only to IPv4 routes.

This command is inapplicable in multi-device backup scenarios.

Example

# Enable BGP route forwarding between a CPE and BRAS.

<HUAWEI> system-view
[~HUAWEI] aaa
[~HUAWEI-aaa] bgp over ipoe enable