remote-mep mep-id

Function

The remote-mep mep-id command configures an RMEP in an MA.

The undo remote-mep mep-id command deletes an RMEP from an MA.

By default, no RMEP is configured in an MA.

Format

remote-mep mep-id mep-id [ mac mac-address ]

undo remote-mep mep-id mep-id

Parameters

Parameter	Description	Value
mep-id	Specifies the ID of an RMEP.	The value is an integer ranging from 1 to 8191.
mac mac-address	Specifies the MAC address of an RMEP.	The value is a 12-digit hexadecimal number, in the format of H-H-H. Each H is 4 digits. If an H contains fewer than 4 digits, the left-most digits are padded with zeros. For example, e0 is displayed as 00e0.

Parameter

Description

Value

mep-id

Specifies the ID of an RMEP.

The value is an integer ranging from 1 to 8191.

mac mac-address

Specifies the MAC address of an RMEP.

The value is a 12-digit hexadecimal number, in the format of H-H-H. Each H is 4 digits. If an H contains fewer than 4 digits, the left-most digits are padded with zeros. For example, e0 is displayed as 00e0.

Views

MA view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
y1731	write

Usage Guidelines

Usage Scenario

CFM monitors the connectivity of a link between a MEP and an RMEP. The mep mep-id command configures a local MEP. The remote-mep command configures an RMEP in the same MA as the local MEP.

The RMEP configurations supported in various access scenarios are the same as MEP configurations

Prerequisites

An MD and an MA have been configured using the cfm md and ma commands, respectively.

Follow-up Procedure

Run the remote-mep ccm-receive enable command to enable the local MEP to receive CCMs from the RMEP.

Precautions

Before modifying the bridge MAC address of an RMEP, delete the RMEP from an MA and reconfigure the RMEP.

If there are multiple MEPs in an MA, an RMEP corresponds to multiple MEPs when the RMEP is configured.
If there is a single MEP in an MA, one or more RMEPs correspond to the single MEP when one or more RMEPs are configured.
The RMEP ID must be different from the MEP ID configured on a local interface.

Example

# Configure RMEP 10 in the MA named ma1 and set its MAC address to 00e0-fc12-7890.

<HUAWEI> system-view
[~HUAWEI] cfm enable
[*HUAWEI] cfm md md1
[*HUAWEI-md-md1] ma ma1
[*HUAWEI-md-md1-ma-ma1] remote-mep mep-id 10 mac 00e0-fc12-7890