The damp-interface ignore-global command enables an interface to ignore the global damp-interface function.
The undo damp-interface ignore-global command disables an interface from ignoring the global damp-interface function.
By default, the damp-interface function on an interface is the same as the global configuration.
100GE-Trunk member Layer 2 interface view, 100GE-Trunk member interface view, Layer 2 100GE interface view, 100GE interface view, Layer 2 10GE interface view, 10GE interface view, 25GE-L2 view, 25GE interface view, 400GE-L2 view, 400GE interface view, 40GE-Trunk member Layer 2 interface view, 40GE-Trunk member interface view, Layer 2 40GE interface view, 40GE interface view, Layer 2 50GE interface view, 50GE interface view, Layer 2 GE interface view, GE optical interface view, GE interface view, GE electrical interface view
Usage Scenario
If the damp-interface function is enabled globally using the damp-interface enable command run in the system view but you want to disable this function on some interfaces, run the damp-interface ignore-global command on these interfaces to enable them to ignore the global damp-interface function.
Configuration Impact
After the damp-interface ignore-global command is run on an interface, the global damp-interface function stops taking effect on the interface.