damp-interface mode tx-off (interface view)

Function

The damp-interface mode tx-off command disables an interface suppressed due to status flapping from sending signals.

The undo damp-interface mode tx-off command cancels the configuration.

By default, an interface suppressed due to status flapping can send signals.

Format

damp-interface mode tx-off

undo damp-interface mode tx-off

Parameters

None

Views

100GE-Trunk member Layer 2 interface view, 100GE-Trunk member interface view, Layer 2 100GE interface view, 100GE interface view, Layer 2 10GE interface view, 10GE interface view, 25GE-L2 view, 25GE interface view, 400GE-L2 view, 400GE interface view, 40GE-Trunk member Layer 2 interface view, 40GE-Trunk member interface view, Layer 2 40GE interface view, 40GE interface view, Layer 2 50GE interface view, 50GE interface view, Layer 2 GE interface view, GE optical interface view, GE interface view, GE electrical interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
interface-mgr	write

Usage Guidelines

Usage Scenario

To disable an interface suppressed due to status flapping from sending signals, run the damp-interface mode tx-off command. This enables the peer end to know that the local interface is unavailable.

Prerequisites

Status flapping suppression has been enabled on a physical interface using the damp-interface enable command.

Configuration Impact

If the local interface is disabled from sending signals, the peer interface regards it Down.

If the local interface is not suppressed, it can send signals to the peer interface. In this case, the peer interface regards it Up.

Example

# Disable an interface suppressed due to status flapping from sending signals.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/16
[~HUAWEI-GigabitEthernet0/1/16] damp-interface enable
[~HUAWEI-GigabitEthernet0/1/16] damp-interface mode tx-off