default-ip-bfd transparent-transmission enable

Function

The default-ip-bfd transparent-transmission enable command configures multicast IPv4 BFD packets on an interface and its sub-interfaces to be transparently transmitted.

The undo default-ip-bfd transparent-transmission enable command configures multicast IPv4 BFD packets on an interface and its sub-interfaces to be sent to the CPU.

By default, multicast IPv4 BFD packets on an interface and its sub-interfaces are sent to the CPU.

Format

default-ip-bfd transparent-transmission enable

undo default-ip-bfd transparent-transmission enable

Parameters

None

Views

100GE interface view, 10G LAN interface view, 10G WAN interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE interface view, Eth-Trunk interface view, FlexE interface view, GE optical interface view, GE electrical interface view, XGE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bfd	write

Usage Guidelines

Usage Scenario

On a network, if a customer-side router that functions as a CE has the default BFD function enabled, the default BFD packets received by a PE are sent to the CPU instead of being transparently transmitted to the peer CE. After BFD is enabled globally on a device, you can run the default-ip-bfd transparent-transmission enable command on an interface to configure multicast IPv4 BFD packets to be transparently transmitted on the interface and its sub-interfaces even if all interfaces can capture BFD packets.

Precautions

This command can be run only on an interface. After the command is run, the command configuration takes effect on all the sub-interfaces of the interface.

Example

# Configure multicast IPv4 BFD packets on interface GE 0/1/0 and its sub-interfaces to be transparently transmitted.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/0
[~HUAWEI-GigabitEthernet0/1/0] default-ip-bfd transparent-transmission enable