display mpls static-l2vc brief

Format

display mpls static-l2vc [ hard-pipe ] brief

Parameters

Parameter	Description	Value
hard-pipe	Indicates an IP hard pipe. Only the NetEngine 8000 F1A supports this parameter.	-
brief	Displays summary static PW information.	-

Parameter

Description

Value

hard-pipe

Indicates an IP hard pipe.

Only the NetEngine 8000 F1A supports this parameter.

-

brief

Displays summary static PW information.

-

Views

All views

Default Level

1: Monitoring level

Task Name and Operations

Task Name	Operations
l2vpn	read

Usage Guidelines

Usage Scenario

To view information about static VCs on an interface, run the display mpls static-l2vc command with the interface name specified.

To check information about a hard-pipe static VPWS PW after configuring it, run the display mpls static-l2vc hard-pipe command.

Precautions

If no hard-pipe static PW is configured when you run the display mpls static-l2vc hard-pipe command, no information is displayed after the command is run.

Example

The actual command output varies according to the device. The command output here is only an example.

# Display summary static PW information.

<HUAWEI> display mpls static-l2vc brief
 Total Switch VC : 1, 0 up, 1 down

*Switch-l2vc type             : LDP<---->LDP
 Peer IP Address              : 1.1.1.1, 2.2.2.2
 VC ID                        : 100, 200
 VC Type                      : Ethernet
 VC State                     : down
 Session State                : down, down

**Table 1** Description of the **display mpls static-l2vc brief** command output
Item	Description
Total Switch VC	Number of established SVCs, including the number of SVCs in the Up state and the number of SVCs in the Down state.
VC State	VC status: down. up.
VC ID	ID that uniquely identifies a VC. The VC ID is displayed as 0 if no VC ID is specified in the mpls static-l2vc command.
VC Type	VC encapsulation type: ATM 1to1 VCC. ATM 1to1 VPC. ATM AAL5 PDU. ATM AAL5 SDU. ATM Nto1 VCC. ATM Nto1 VPC. ATM Transparent cell. CEP. CESoPSN basic mode. Ethernet. IP-interworking. IP-layer2. PPP. SAT E1 over Packet. SAT E3 over Packet. SAT T1 over Packet. VLAN.
Peer IP Address	IP address of a neighbor.
Session State	Status of the LDP session: up. down.