display access dhcpv6 reconfigure configuration
Function
The display access dhcpv6 reconfigure configuration command displays the configuration of the Reconfigure function for online DHCPv6 users.
This command is supported only on the NetEngine 8000 F1A.
Usage Guidelines
Usage Scenario
In a Layer 2 user access scenario where a BRAS is required to log out online DHCPv6 users, to allow clients to detect user logouts immediately after users are offline so that the clients can re-dial up for login, run the access dhcpv6-reconfigure command to enable the BRAS to send Reconfigure messages to clients. To display the configuration of the Reconfigure function, run the display access dhcpv6 reconfigure configuration command.
Precautions
In VS mode, this command is supported only by the admin VS.
Example
The actual command output varies according to the device. The command output here is only an example.
<HUAWEI> display access dhcpv6 reconfigure configuration
-------------------------------------------------------------------------
Global configuration
-------------------------------------------------------------------------
Reconfigure function local :enable
Reconfigure authentication method :Reconfigure Key
Reconfigure retransmit times :3
-------------------------------------------------------------------------
| Item | Description |
|---|---|
| Global configuration | Global configuration information. |
| Reconfigure function local | Status of the function to send Reconfigure messages to client. |
| Reconfigure authentication method | Authentication method supported by Reconfigure messages. |
| Reconfigure retransmit times | Maximum retransmission times for Reconfigure messages. |