display ip-pool max-usage pool

Function

The display ip-pool max-usage pool command displays the historical maximum usage of addresses in an IPv4 address pool.

This command is supported only on the NetEngine 8000 F1A.

Format

display ip-pool max-usage pool [ pool-name ]

Parameters

Parameter	Description	Value
pool-name	Specifies an address pool.	The value is a string of 1 to 128 case-insensitive characters.

Parameter

Description

Value

pool-name

Specifies an address pool.

The value is a string of 1 to 128 case-insensitive characters.

Views

All views

Default Level

1: Monitoring level

Task Name and Operations

Task Name	Operations
ippool	read

Usage Guidelines

Usage Scenario

To check the historical maximum usage of addresses in an IPv4 address pool or to check the IPv4 address pool that has the maximum number of allocated addresses, run the display ip-pool max-usage command. This facilitates IPv4 address planning.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

The actual command output varies according to the device. The command output here is only an example.

# Display the historical maximum usage of addresses in the IPv4 address pool p1.

<HUAWEI> display ip-pool max-usage pool p1
--------------------------------------------------------------------
  Pool name                      PoolLen    Used                 Time
  --------------------------------------------------------------------
  p1                                  99       9  2017-05-07 16:56:06
  --------------------------------------------------------------------

**Table 1** Description of the **display ip-pool max-usage pool** command output
Item	Description
Pool name	Address pool name.
PoolLen	Specifies the length of an address pool, that is, the number of IP addresses contained in the address pool when the maximum number of addresses were used.
Used	Maximum number of addresses that were used.
Time	Time when the maximum number of addresses were used.