display pnp state
Usage Guidelines
Usage Scenario
To check whether a device works in the PNP state or ZTP state, run the display pnp state command.If the device works in the PNP state or ZTP state, a message is displayed. If the device does not work in the PNP state, no message is displayed.
Precautions
In VS mode, this command is supported only by the admin VS.
Example
The actual command output varies according to the device. The command output here is only an example.
# Display the PNP or ZTP state of the device.
<HUAWEI> display pnp state
The device is on PNP state. If you want to setup by manual, you can undo PNP in system view with "undo pnp enable" command.