timer end-x update-delay

Function

The timer end-x update-delay command configures a delay for sending the static End.X SID to the FES table.

The undo timer end-x update-delay command restores the default configuration.

By default, the static End.X SID is sent to the FES table immediately.

Format

timer end-x update-delay delay-time

undo timer end-x update-delay [ delay-time ]

Parameters

Parameter	Description	Value
delay-time	Specifies the delay time for the static End.X SID to delay the delivery of the FES table.	The value is an integer that ranges from 0 to 600000, in milliseconds.

Parameter

Description

Value

delay-time

Specifies the delay time for the static End.X SID to delay the delivery of the FES table.

The value is an integer that ranges from 0 to 600000, in milliseconds.

Views

Segment routing IPv6 view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
segr	write

Usage Guidelines

Usage Scenario

You can run the timer end-x update-delay command to configure a delay for sending the static End.X SID to the FES table. This command is mainly used when the status of the outbound interface associated with a static End.X SID changes from Down to Up.

For example, if a neighbor fails, the local interface connected to the neighbor goes Down, and the End.X SID associated with the local interface becomes invalid.

If the fault on the neighboring device is rectified but route convergence is not complete, the neighboring device may not have the forwarding capability. To prevent traffic from being forwarded to neighbors and causing packet loss, you can run this command to configure a delay for sending the static End.X SID to the FES table.

Example

# Configure the delay time for the static End.X SID to be sent to the FES table.

<HUAWEI> system-view
[~HUAWEI] segment-routing ipv6
[*HUAWEI-segment-routing-ipv6] timer end-x update-delay 100