peer enable (BGP-VPNv4-multicast address family view) (group)

Function

The peer enable command enables a BGP device to exchange routes with a specified peer group in the address family view.

The undo peer enable command disables a BGP device from exchanging routes with a specified peer group.

By default, only the peer in the BGP IPv4 unicast address family view is automatically enabled.

Format

peer group-name enable

undo peer group-name enable

Parameters

Parameter	Description	Value
group-name	Specifies the name of a peer group.	The name is a string of 1 to 47 case-sensitive characters, with spaces not supported. When double quotation marks are used around the string, spaces are allowed in the string.

Parameter

Description

Value

group-name

Specifies the name of a peer group.

The name is a string of 1 to 47 case-sensitive characters, with spaces not supported. When double quotation marks are used around the string, spaces are allowed in the string.

Views

BGP-VPNv4-multicast address family view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bgp	write

Usage Guidelines

Usage Scenario

By default, only peers in the BGP IPv4 unicast address family are automatically enabled. After the peer as-number command is used in the BGP view, the system automatically runs the peer enable command to enable a peer. In other address family view, however, a peer must be enabled manually.

After the undo default ipv4-unicast command is run, the peer enable command needs to be run in the BGP view or the BGP-IPv4 unicast address family view to enable the IPv4 unicast address family for the created BGP peer.

Configuration Impact

Enabling or disabling a BGP peer in an address family, for example, running the peer enable command or the undo peer enable command in a VPNv4 address family, causes teardown and re-establishment of the BGP connection of the peer in other address families.

Precautions

To configure a 6PE device to send labeled routes, specify an IPv4 unicast address for the peer of the device in the IPv6 unicast address family view.

To run the command in the BGP VPN instance IPv4 address family view or BGP VPN instance IPv6 address family view, ensure that the related BGP peers and BGP peer groups have been configured in the BGP VPN instance.

If the peer enable command is run for a peer in the BGP public address family view when the peer has established peer relationships with other peers in other address families, these peer relationships will be disconnected and reestablished, which may cause route flapping. Therefore, exercise caution when running this command.

Example

# Enable a BGP device to exchange routes with a specified peer group.

<HUAWEI> system-view
[~HUAWEI] bgp 100
[~HUAWEI-bgp] group a internal
[*HUAWEI-bgp] ipv4-family vpnv4-multicast
[*HUAWEI-bgp-af-vpnv4-multicast] peer a enable