dcn ospf timer hello (DCN view)

Function

The dcn ospf timer hello command sets the interval at which Hello packets are sent.

The undo dcn ospf timer hello command restores the default interval.

By default, P2P DCN interfaces send Hello packets at an interval of 10 seconds.

Format

dcn ospf timer hello interval

undo dcn ospf timer hello

Parameters

Parameter	Description	Value
interval	Specifies the interval at which Hello packets are sent.	The value is an integer ranging from 1 to 65535, in seconds.

Parameter

Description

Value

interval

Specifies the interval at which Hello packets are sent.

The value is an integer ranging from 1 to 65535, in seconds.

Views

DCN view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
dcn	write

Usage Guidelines

Usage Scenario

To set the interval at which DCN serial interfaces send hello packets, run the dcn ospf timer hello command.

Prerequisites

The DCN feature has been enabled globally using the dcn (interface view) command in the interface view, or DCN communication through sub-interfaces 4094 has been enabled using the dcn mode vlan command in the GE interface view.

Precautions

If the dcn ospf timer hello command is run in the DCN view, the hello packet sending interval is set for all DCN interfaces.

If the dcn ospf timer hello command is run in both the interface and DCN views, only the configuration in the interface view takes effect.

In VS mode, this command is supported only by the admin VS.

Example

# Configure the DCN serial interfaces to send Hello packets every 20 seconds.

<HUAWEI> system-view
[~HUAWEI] dcn
Warning: This operation will enable DCN function. Continue? [Y/N]:y
[*HUAWEI-dcn] dcn ospf timer hello 20